Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Security How To

Introduction

In Part One of this series, we established a working definition of our target, i.e. what has to be done, and in what order, to Cerberus the lowly IDS firewall to make it a UTM Appliance.

As we saw, there are six areas that need to be upgraded to grab the prize: IDS/IPS, Anti-Virus, Content Filtering, Traffic Control, Load Balancing and Failover, and finally Anti-Spam. We’ll step through each of the six functional areas and show you how to install and configure the required packages.

Once we have everything set up, we’ll look at performance and see if Cerberus with PFSense is able to be called a UTM appliance. But first, we need to attend to some prerequisites, which include setting up a second WAN interface for load balancing and fail-over and installing Squid, a critical piece needed for content filtering and anti-virus.

Multiple WAN Setup

For the purposes of this upgrade, we’ve ordered service from another ISP. You may remember we had previously set up a little-used guest wireless interface to use for our second ISP WAN connection for testing. Now we need the real thing.

The setup is straightforward—enable the interface using parameters provided by your ISP. In most cases this is just DHCP. Note, the FTP Proxy should be disabled on all WAN interfaces, including this one. Figure 1 shows the settings.

Enabling the second WAN interfaceFigure 1: Enabling the second WAN interface

You can test your second WAN interface by changing the gateway on the already-established LAN routing rule, the one that directs LAN traffic through our current default gateway. Get the gateway for OPT1 from Status Interfaces, then under Firewall->Rules, edit the LAN rule, changing the gateway drop-down value to the OPT1 gateway IP as shown in Figure 2.

Testing the second WAN

Figure 2: Testing the second WAN

Now from a web browser, visit the GRC Shields-Up Site. Your IP should correspond to your IP address from the secondary ISP. If you can’t reach any web site, verify that the link is active by going to your modem/router diagnostics. If the IP Address corresponds to your primary ISP, turn on logging for the routing rule, close your browser, and reboot your installation. Check the log once you are back up. If you still don’t see the new IP address, verify your gateway settings. But hold off changing it back to the default gateway until after we’ve tested our IDS changes below.

That’s it, done. We can now hang Snort on the Secondary WAN interface and  set up the needed proxy servers. Load balancing and failover will come later.

More Stuff

Wi-Fi System Tools
Check out the new Wi-Fi System Charts, Ranker and Finder!

Featured Sponsors



Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

I'm running an RT-AC88U with stock firmware. Everything is fine with the current settings. However I would like to be able to adjust the MTU value on ...
Hi, the first of all thank you for this great firmware. Yesterday I bought a AC66U_B1 and I don't know how to turn off|on wifi with WPS button. It is ...
Hi all,Is there a way to change the minidlna.conf file on the router permanently?I know that a reboot will remove the change - but in other custom bui...
Hi, I am trying to recover a router I purchased from eBay. It's Belkin F9K1124 AC1900. I tried to recover with UART but this is not recognising any co...
This might seem a stupid question (and maybe it is), but is ASUS WebStorage (on www.asuswebstorage.com) a real ASUS service?Today I received an offer ...

Don't Miss These

  • 1
  • 2
  • 3